Installation Guide
Table Of Contents
- Conext™ SW Inverter Charger
- Exclusion for Documentation
- Document Number: 975-0638-01-01 Revision: Rev A Date: 12-2012
- Contact Information www.schneider-electric.com
- Information About Your System
- About This Guide
- Important Safety Instructions
- Precautions When Working With Batteries
- Regulatory
- FCC Information to the User
- Introduction
- Materials List
- Key Features
- Key Features Explained
- Multiple Unit Configuration
- Generator Support
- Basic Protection Features
- Components and Mechanical Features
- System Components
- Xanbus System
- Xanbus-enabled Products and Other Accessories
- Conext SW Inverter/Charger Mechanical Features
- Conext SW Front and Side Panels
- Conext SW AC/DC/Ports Side Panel
- Operation
- Start Up Behavior
- Inverter Operation Using the Front Panel
- Operating Limits for Inverter Operation
- Operating Limits for Charger Operation
- Inverter/Charger Operation using the System Control Panel (SCP)
- SCP Features
- Using the Standby Button
- SCP Navigation
- Changing Operational Settings
- Configuration via SCP
- Viewing the Firmware Revision Number
- Setting the Time and Date
- Viewing the Basic and Advanced Settings Menus
- Configuring Basic Settings
- Configuring Advanced Settings
- Inverter Settings Menu
- Charger Settings Menu
- AC Settings
- Gen Support Settings
- Multi Unit Config Menu
- Restoring Factory Default Settings
- Using the Advanced Features
- Configuration Sheet
- Troubleshooting
- General Troubleshooting Guidelines
- Inverter Applications
- View Device Info Logs
- Troubleshooting the Conext SW via the SCP
- Fault Detection Types
- Warning Types
- Specifications
- Inverter Specifications
- Charger Specifications
- AC Transfer Specifications
- Physical Specifications
- Environmental Specifications
- Regulatory
Safety
viii 975-0638-01-01 Rev A
Regulatory
The Conext SW Inverter/Charger is certified to appropriate US and Canadian
standards. For more information see “Regulatory Approvals” under
Specifications.
The Conext SW Inverter/Charger is intended to be used for off-grid, backup,
solar, and hybrid applications.
It is not intended for other applications as it may not comply with the additional
safety code requirements needed for those other applications. See “Limitations
On Use” below.
CAUTION
CHEMICAL HAZARD
• Never allow battery acid to drip when reading specific gravity or filling
battery.
• Make sure the area around the battery is well ventilated.
• Make sure the voltage of the batteries matches the output voltage of the
inverter/charger.
• Study and follow all of the battery manufacturer's specific precautions,
such as removing or not removing cell caps while charging, whether
equalization is acceptable for your battery, and recommended rates of
charge.
Failure to follow these instructions can result in moderate or minor injury.
NOTICE
RISK OF INVERTER/CHARGER DAMAGE
Never place the Conext SW Inverter/Charger unit directly above batteries;
gases from a battery will corrode and damage the inverter/charger.
Failure to follow these instructions can result in damage to equipment.
WARNING
LI
LIMITATIONS ON USE
Do not use in connection with life support systems or other medical
equipment.
Failure to follow these instructions can result in death or serious injury.
ConextSW-NA-OwnersGuide.book Page viii Thursday, December 20, 2012 2:00 PM