Installation Guide
Table Of Contents
- Conext™ SW Inverter Charger
- Exclusion for Documentation
- Document Number: 975-0638-01-01 Revision: Rev A Date: 12-2012
- Contact Information www.schneider-electric.com
- Information About Your System
- About This Guide
- Important Safety Instructions
- Precautions When Working With Batteries
- Regulatory
- FCC Information to the User
- Introduction
- Materials List
- Key Features
- Key Features Explained
- Multiple Unit Configuration
- Generator Support
- Basic Protection Features
- Components and Mechanical Features
- System Components
- Xanbus System
- Xanbus-enabled Products and Other Accessories
- Conext SW Inverter/Charger Mechanical Features
- Conext SW Front and Side Panels
- Conext SW AC/DC/Ports Side Panel
- Operation
- Start Up Behavior
- Inverter Operation Using the Front Panel
- Operating Limits for Inverter Operation
- Operating Limits for Charger Operation
- Inverter/Charger Operation using the System Control Panel (SCP)
- SCP Features
- Using the Standby Button
- SCP Navigation
- Changing Operational Settings
- Configuration via SCP
- Viewing the Firmware Revision Number
- Setting the Time and Date
- Viewing the Basic and Advanced Settings Menus
- Configuring Basic Settings
- Configuring Advanced Settings
- Inverter Settings Menu
- Charger Settings Menu
- AC Settings
- Gen Support Settings
- Multi Unit Config Menu
- Restoring Factory Default Settings
- Using the Advanced Features
- Configuration Sheet
- Troubleshooting
- General Troubleshooting Guidelines
- Inverter Applications
- View Device Info Logs
- Troubleshooting the Conext SW via the SCP
- Fault Detection Types
- Warning Types
- Specifications
- Inverter Specifications
- Charger Specifications
- AC Transfer Specifications
- Physical Specifications
- Environmental Specifications
- Regulatory
Introduction
1–6 975-0638-01-01 Rev A
Basic Protection Features
The Conext SW has the following protection features:
• Over temperature shutdown for critical components such as the transformer
and the power board
• Battery temperature sensor (BTS) failure/battery temperature out-of-range
fault protection
• DC output over voltage protection during charge mode
• AC output overload and short circuit protection during invert mode
• AC backfeed
1
protection
The Battery Temperature Sensor (BTS) provides these protection features:
• battery over temperature charging protection preventing battery charging at
140 °F (60 °C) or higher, and
• charging voltage compensation based on the temperature of the battery the
BTS is connected to.
1.An AC backfeed error occurs when the AC output of the inverter/charger is connected or
routed back to the inverter/charger’s AC input terminal or if the an AC internal transfer relay error
is detected.
ConextSW-NA-OwnersGuide.book Page 6 Thursday, December 20, 2012 2:00 PM