Installation Guide
Table Of Contents
- Conextâ„¢ SW Inverter Charger
- Exclusion for Documentation
- Document Number: 975-0638-01-01 Revision: Rev A Date: 12-2012
- Contact Information www.schneider-electric.com
- Information About Your System
- About This Guide
- Important Safety Instructions
- Precautions When Working With Batteries
- Regulatory
- FCC Information to the User
- Introduction
- Materials List
- Key Features
- Key Features Explained
- Multiple Unit Configuration
- Generator Support
- Basic Protection Features
- Components and Mechanical Features
- System Components
- Xanbus System
- Xanbus-enabled Products and Other Accessories
- Conext SW Inverter/Charger Mechanical Features
- Conext SW Front and Side Panels
- Conext SW AC/DC/Ports Side Panel
- Operation
- Start Up Behavior
- Inverter Operation Using the Front Panel
- Operating Limits for Inverter Operation
- Operating Limits for Charger Operation
- Inverter/Charger Operation using the System Control Panel (SCP)
- SCP Features
- Using the Standby Button
- SCP Navigation
- Changing Operational Settings
- Configuration via SCP
- Viewing the Firmware Revision Number
- Setting the Time and Date
- Viewing the Basic and Advanced Settings Menus
- Configuring Basic Settings
- Configuring Advanced Settings
- Inverter Settings Menu
- Charger Settings Menu
- AC Settings
- Gen Support Settings
- Multi Unit Config Menu
- Restoring Factory Default Settings
- Using the Advanced Features
- Configuration Sheet
- Troubleshooting
- General Troubleshooting Guidelines
- Inverter Applications
- View Device Info Logs
- Troubleshooting the Conext SW via the SCP
- Fault Detection Types
- Warning Types
- Specifications
- Inverter Specifications
- Charger Specifications
- AC Transfer Specifications
- Physical Specifications
- Environmental Specifications
- Regulatory
System Components
975-0638-01-01 Rev A 2–3
Xanbus-enabled Products and Other Accessories
Product/Accessory (Shown above) Product Number/s
1 Conext SW DC Switch Gear* 865-1016*
2 Conext SW AC Switch Gear 865-1017
3 Stacking Kit (not shown) 865-1019
4 MPPT 60 150 Solar Charge Controller 865-1030-1
MPPT 80 600 Solar Charge Controller (not shown) 865-1032
5 Conext SW On/Off Remote Switch (not shown) 865-1052
6 System Control Panel (SCP) 865-1050
7 Conext CM (not shown) 865-1058
8 Automatic Generator Start (AGS) 865-1060
9 Battery Temperature Sensor (BTS) 808-0232-02
10 3-ft network cable (0.9 m) 809-0935
25-ft network cable (7.6 m) 809-0940
75-ft network cable (22.9 m) 809-0942
*
required accessory for code-compliant installation in Canada and USA.
/
7.6 m cable 22.9 m cable0.9 m cable
4
1
2
6
8
9
10
7
ConextSW-NA-OwnersGuide.book Page 3 Thursday, December 20, 2012 2:00 PM