Installation Guide

Operation
3–4 975-0638-01-01 Rev A
Fault Detections and Warnings A fault detection condition affects the
operation of the unit. A fault detection sometimes requires user intervention by
clearing the condition using the Clear Fault button on the inverter/charger’s front
panel. Press the button once to clear the condition. See “Troubleshooting” on
page 5–1 for information on clearing fault detections from the SCP.
A warning alerts you to a condition that could possibly affect operation of the
unit. A warning usually precedes a fault detection condition.
Table 3-1 Front Panel LEDs
Icon LED Status Action (or Status Item)
Steady
Green
If generator or grid AC is unavailable
and operating conditions are met,
the Conext SW will produce AC
voltage to power loads.
You can run your appliances from
the inverter.
Flashing
Green
The inverter is assisting a generator
in powering loads.
You can run your appliances from
the inverter.
Steady
Green
When the Conext SW is connected
to a generator or grid and is
producing qualified AC, the AC IN
light illuminates.
You can run your appliances using
passed-through AC.
Flashing
Green
Conext SW is connected to a
qualified AC source, is charging and
passing-through power to AC loads.
Your battery bank is being
replenished and AC loads are
receiving power from a qualified AC
source.
Steady
Red
A fault has been detected on the
network.
Investigate and clear the fault
detection condition.
Flashing
Red
A warning is detected. Investigate by examining warning
logs on SCP.
IMPORTANT: If you are having problems with any of your loads, refer to “Inverter
Applications” on page 5–3.
ConextSW-NA-OwnersGuide.book Page 4 Thursday, December 20, 2012 2:00 PM