Installation Guide
Table Of Contents
- Conext™ SW Inverter Charger
- Exclusion for Documentation
- Document Number: 975-0638-01-01 Revision: Rev A Date: 12-2012
- Contact Information www.schneider-electric.com
- Information About Your System
- About This Guide
- Important Safety Instructions
- Precautions When Working With Batteries
- Regulatory
- FCC Information to the User
- Introduction
- Materials List
- Key Features
- Key Features Explained
- Multiple Unit Configuration
- Generator Support
- Basic Protection Features
- Components and Mechanical Features
- System Components
- Xanbus System
- Xanbus-enabled Products and Other Accessories
- Conext SW Inverter/Charger Mechanical Features
- Conext SW Front and Side Panels
- Conext SW AC/DC/Ports Side Panel
- Operation
- Start Up Behavior
- Inverter Operation Using the Front Panel
- Operating Limits for Inverter Operation
- Operating Limits for Charger Operation
- Inverter/Charger Operation using the System Control Panel (SCP)
- SCP Features
- Using the Standby Button
- SCP Navigation
- Changing Operational Settings
- Configuration via SCP
- Viewing the Firmware Revision Number
- Setting the Time and Date
- Viewing the Basic and Advanced Settings Menus
- Configuring Basic Settings
- Configuring Advanced Settings
- Inverter Settings Menu
- Charger Settings Menu
- AC Settings
- Gen Support Settings
- Multi Unit Config Menu
- Restoring Factory Default Settings
- Using the Advanced Features
- Configuration Sheet
- Troubleshooting
- General Troubleshooting Guidelines
- Inverter Applications
- View Device Info Logs
- Troubleshooting the Conext SW via the SCP
- Fault Detection Types
- Warning Types
- Specifications
- Inverter Specifications
- Charger Specifications
- AC Transfer Specifications
- Physical Specifications
- Environmental Specifications
- Regulatory
Inverter/Charger Operation using the System Control Panel (SCP)
975-0638-01-01 Rev A 3–7
Inverter/Charger Operation using the System Control Panel (SCP)
This section contains detailed information and procedures for using your Conext
SW in conjunction with the SCP.
If you’re using the SCP to operate or monitor the status of the unit, you may also
refer to the System Control Panel Owner’s Guide.
The SCP provides operating, configuring, and monitoring capability for your
Xanbus system.
The System Control Panel:
• Monitors activity throughout your power system.
• Displays the latest information about your inverter/charger, battery voltage
level, battery charge output, and generator start and stop activity.
• Displays the settings for each Xanbus-enabled device in the system.
• Enables you to adjust the settings for each Xanbus-enabled device in the
system.
• Preserves all of its settings if system power is interrupted. After power is
restored, you don’t have to reconfigure the SCP or any of the Xanbus-
enabled devices connected to it.
The SCP provides remote configuration and monitoring capabilities for the
Conext SW and other Xanbus-enabled devices in the power system. Please refer
to the System Control Panel Owner’s Guide for complete information on using the
System Control Panel.
You can monitor Conext SW operation on the SCP using the:
• System Status screen (see page 3–10)
• Conext SW Home screen (see page 3–11)
• Conext SW Meters Menu (see page 3–15)
WARNING
LI
LIMITATIONS ON USE
Do not use in connection with life support systems or other medical
equipment.
Failure to follow these instructions can result in death or serious injury.
ConextSW-NA-OwnersGuide.book Page 7 Thursday, December 20, 2012 2:00 PM