Installation Guide
Table Of Contents
- Conextâ„¢ SW Inverter Charger
- Exclusion for Documentation
- Document Number: 975-0638-01-01 Revision: Rev A Date: 12-2012
- Contact Information www.schneider-electric.com
- Information About Your System
- About This Guide
- Important Safety Instructions
- Precautions When Working With Batteries
- Regulatory
- FCC Information to the User
- Introduction
- Materials List
- Key Features
- Key Features Explained
- Multiple Unit Configuration
- Generator Support
- Basic Protection Features
- Components and Mechanical Features
- System Components
- Xanbus System
- Xanbus-enabled Products and Other Accessories
- Conext SW Inverter/Charger Mechanical Features
- Conext SW Front and Side Panels
- Conext SW AC/DC/Ports Side Panel
- Operation
- Start Up Behavior
- Inverter Operation Using the Front Panel
- Operating Limits for Inverter Operation
- Operating Limits for Charger Operation
- Inverter/Charger Operation using the System Control Panel (SCP)
- SCP Features
- Using the Standby Button
- SCP Navigation
- Changing Operational Settings
- Configuration via SCP
- Viewing the Firmware Revision Number
- Setting the Time and Date
- Viewing the Basic and Advanced Settings Menus
- Configuring Basic Settings
- Configuring Advanced Settings
- Inverter Settings Menu
- Charger Settings Menu
- AC Settings
- Gen Support Settings
- Multi Unit Config Menu
- Restoring Factory Default Settings
- Using the Advanced Features
- Configuration Sheet
- Troubleshooting
- General Troubleshooting Guidelines
- Inverter Applications
- View Device Info Logs
- Troubleshooting the Conext SW via the SCP
- Fault Detection Types
- Warning Types
- Specifications
- Inverter Specifications
- Charger Specifications
- AC Transfer Specifications
- Physical Specifications
- Environmental Specifications
- Regulatory
Operation
3–8 975-0638-01-01 Rev A
SCP Features
Feature Description
1 Fault/Warning light indicates a device has a fault detection or warning
condition and requires attention. The light flashes when a warning
occurs and turns on steadily when a fault detection occurs.
2 Enter button confirms selection of a menu item or displays the next
screen.
3 Up arrow button scrolls upward through screen text or increases a
selected value.
4 Down arrow button scrolls downward through screen text or
decreases a selected value.
5 Exit button cancels selection of a menu item or displays the previous
screen.
6 Screen shows menus, settings, and system information.
7 Standby button disables inverting and charging on all Conext SW
units in the system when pressed and held for one to two seconds. To
enable inverting and charging, press and hold the Standby button
again for one to two seconds.
Enter Exit
Fault/Warning
Standby
1
2345
7
6
ConextSW-NA-OwnersGuide.book Page 8 Thursday, December 20, 2012 2:00 PM