Installation Guide
Table Of Contents
- Conextâ„¢ SW Inverter Charger
- Exclusion for Documentation
- Document Number: 975-0638-01-01 Revision: Rev A Date: 12-2012
- Contact Information www.schneider-electric.com
- Information About Your System
- About This Guide
- Important Safety Instructions
- Precautions When Working With Batteries
- Regulatory
- FCC Information to the User
- Introduction
- Materials List
- Key Features
- Key Features Explained
- Multiple Unit Configuration
- Generator Support
- Basic Protection Features
- Components and Mechanical Features
- System Components
- Xanbus System
- Xanbus-enabled Products and Other Accessories
- Conext SW Inverter/Charger Mechanical Features
- Conext SW Front and Side Panels
- Conext SW AC/DC/Ports Side Panel
- Operation
- Start Up Behavior
- Inverter Operation Using the Front Panel
- Operating Limits for Inverter Operation
- Operating Limits for Charger Operation
- Inverter/Charger Operation using the System Control Panel (SCP)
- SCP Features
- Using the Standby Button
- SCP Navigation
- Changing Operational Settings
- Configuration via SCP
- Viewing the Firmware Revision Number
- Setting the Time and Date
- Viewing the Basic and Advanced Settings Menus
- Configuring Basic Settings
- Configuring Advanced Settings
- Inverter Settings Menu
- Charger Settings Menu
- AC Settings
- Gen Support Settings
- Multi Unit Config Menu
- Restoring Factory Default Settings
- Using the Advanced Features
- Configuration Sheet
- Troubleshooting
- General Troubleshooting Guidelines
- Inverter Applications
- View Device Info Logs
- Troubleshooting the Conext SW via the SCP
- Fault Detection Types
- Warning Types
- Specifications
- Inverter Specifications
- Charger Specifications
- AC Transfer Specifications
- Physical Specifications
- Environmental Specifications
- Regulatory
Configuring Advanced Settings
975-0638-01-01 Rev A 4–21
ACIn Lo Volt Sets the minimum acceptable AC input voltage level from the
AC source (generator or grid).
NOTE: It is recommended to leave this setting to its default
value and not to set it to the maximum allowed. Doing so might
inadvertently derate charging power in jurisdictions where the
nominal AC mains voltage or generator output is at 110 volts.
ACIn Hi Volt Sets the maximum acceptable AC input voltage level from the
AC source (generator or grid).
ACIn Lo Freq Sets the minimum acceptable AC input frequency from the AC
source (generator or grid).
ACIn Hi Freq Sets the maximum acceptable AC input frequency from the AC
source (generator or grid).
AC Qualify
Time
Sets the waiting time in seconds before the charger begins
charging. Charging cannot begin until there is qualified AC
(ACGood) so, the charger counts from the moment AC is
qualified up to the time set in AC Qualify Time before starting
to charge.
Table 4-10 AC Settings menu
Item Description
ConextSW-NA-OwnersGuide.book Page 21 Thursday, December 20, 2012 2:00 PM