Installation Guide
Table Of Contents
- Conext™ SW Inverter Charger
- Exclusion for Documentation
- Document Number: 975-0638-01-01 Revision: Rev A Date: 12-2012
- Contact Information www.schneider-electric.com
- Information About Your System
- About This Guide
- Important Safety Instructions
- Precautions When Working With Batteries
- Regulatory
- FCC Information to the User
- Introduction
- Materials List
- Key Features
- Key Features Explained
- Multiple Unit Configuration
- Generator Support
- Basic Protection Features
- Components and Mechanical Features
- System Components
- Xanbus System
- Xanbus-enabled Products and Other Accessories
- Conext SW Inverter/Charger Mechanical Features
- Conext SW Front and Side Panels
- Conext SW AC/DC/Ports Side Panel
- Operation
- Start Up Behavior
- Inverter Operation Using the Front Panel
- Operating Limits for Inverter Operation
- Operating Limits for Charger Operation
- Inverter/Charger Operation using the System Control Panel (SCP)
- SCP Features
- Using the Standby Button
- SCP Navigation
- Changing Operational Settings
- Configuration via SCP
- Viewing the Firmware Revision Number
- Setting the Time and Date
- Viewing the Basic and Advanced Settings Menus
- Configuring Basic Settings
- Configuring Advanced Settings
- Inverter Settings Menu
- Charger Settings Menu
- AC Settings
- Gen Support Settings
- Multi Unit Config Menu
- Restoring Factory Default Settings
- Using the Advanced Features
- Configuration Sheet
- Troubleshooting
- General Troubleshooting Guidelines
- Inverter Applications
- View Device Info Logs
- Troubleshooting the Conext SW via the SCP
- Fault Detection Types
- Warning Types
- Specifications
- Inverter Specifications
- Charger Specifications
- AC Transfer Specifications
- Physical Specifications
- Environmental Specifications
- Regulatory
Troubleshooting
5–4 975-0638-01-01 Rev A
View Device Info Logs
When troubleshooting, it sometimes becomes necessary to look at information
logs the Conext SW keeps inside its onboard memory. Each log entry is
generated automatically when a “condition” occurs and recorded accordingly in
one of the information logs.
The information logs are organized according to:
• Fault detections
• Warnings
• Events
To view device info logs:
1. From the device Setup menu screen, use the up or down arrow buttons to
highlight View Device Info.
2. Press Enter. The Dev Info screen appears.
3. Use the up or down arrow buttons to select which information log you want to
view then press Enter to confirm a selection. The log screen appears.
4. Use the up or down arrow buttons to scroll the list then press Enter to view
the particular log entry.
5. Press the Exit button to return to previous screens.
Figure 5-1 View Device Info Log
CSW4024 00: Setup
Mode
Clear Faults/Warnings
View Device Info
Basic Settings
[StandBy]
CSW4024 00:Dev Info
View Fault Log
View Warning Log
View Event Log
Fault Log:InvChg
64 May/17 11:35AM
64 May/17 5:58AM
47 May/3 3:15AM
76 Time N/A
ConextSW-NA-OwnersGuide.book Page 4 Thursday, December 20, 2012 2:00 PM