Installation Guide
Table Of Contents
- Conext™ SW Inverter Charger
- Exclusion for Documentation
- Document Number: 975-0638-01-01 Revision: Rev A Date: 12-2012
- Contact Information www.schneider-electric.com
- Information About Your System
- About This Guide
- Important Safety Instructions
- Precautions When Working With Batteries
- Regulatory
- FCC Information to the User
- Introduction
- Materials List
- Key Features
- Key Features Explained
- Multiple Unit Configuration
- Generator Support
- Basic Protection Features
- Components and Mechanical Features
- System Components
- Xanbus System
- Xanbus-enabled Products and Other Accessories
- Conext SW Inverter/Charger Mechanical Features
- Conext SW Front and Side Panels
- Conext SW AC/DC/Ports Side Panel
- Operation
- Start Up Behavior
- Inverter Operation Using the Front Panel
- Operating Limits for Inverter Operation
- Operating Limits for Charger Operation
- Inverter/Charger Operation using the System Control Panel (SCP)
- SCP Features
- Using the Standby Button
- SCP Navigation
- Changing Operational Settings
- Configuration via SCP
- Viewing the Firmware Revision Number
- Setting the Time and Date
- Viewing the Basic and Advanced Settings Menus
- Configuring Basic Settings
- Configuring Advanced Settings
- Inverter Settings Menu
- Charger Settings Menu
- AC Settings
- Gen Support Settings
- Multi Unit Config Menu
- Restoring Factory Default Settings
- Using the Advanced Features
- Configuration Sheet
- Troubleshooting
- General Troubleshooting Guidelines
- Inverter Applications
- View Device Info Logs
- Troubleshooting the Conext SW via the SCP
- Fault Detection Types
- Warning Types
- Specifications
- Inverter Specifications
- Charger Specifications
- AC Transfer Specifications
- Physical Specifications
- Environmental Specifications
- Regulatory
975-0638-01-01 Rev A IX-1
Numerics
2-stage charge mode 16
A
ABS Finish 12
Absorption
12
absorption charging stage
15
AC settings menu
description
20
ACGood
13
Adjustable frequency
3
Advanced menu
5
automatic generator start
11
B
battery equalization 16
Battery power
5
battery type
7, 13, 14
Bulk
12
bulk charging stage
15
C
Charger Block, start and stop 17
charger settings menu
description
13
charging
battery temperature sensor
4
built-in charge formulas
4
dead battery
4
equalization
4
load management
4
custom battery menu
18
D
default settings, restoring 27
Down arrow button
8
E
Enter button 8
equalize charging
16
equalize mode
12
Exit button
8
F
fault/warning LED Xanbus System Control Panel) 8
Float
13
float charging stage
16
G
generator support 12
generator support menu
description
22
H
High surge capacity 3
I
Information about Your System form ii
Invert
12
inverter
serial number
ii
Inverter Block, start and stop
12
inverter settings menu
description
7, 9
K
keypress for system standby mode 9
L
LdSenseActv 13
M
meters screen 15
Multiple Unit Configuration
5
multi unit menu screen
23
Multi-stage charging
3
N
no float charging stage 16
NoFloat
13
P
Power factor correction 3
proof of purchase
ii
Q
qualifying AC 12
Index
ConextSW-NA-OwnersGuide.book Page 1 Thursday, December 20, 2012 2:00 PM