Installation Guide

Wiring the Conext XW+ Inverter/Charger without a PDP
975-0239-01-01 Rev G 3–71
This manual is for use by qualified personnel only
Figure 3-37 DC Connections to a Single Inverter (No PDP)
AC INAC OU T AC IN
GRID
(AC1)
AC
LOAD
GEN
(AC2)
NL1L2NL1L2NL1 L2
4
1
2 3
1. Negative ground/bus
2. Circuit breaker/DC disconnect
3. Fuse block (optional)
4. Vented battery enclosure
Actual wiring requirements may vary.
Cable routing may vary. See Knockout Selection
on page 2-5 and Communications Network
Preparation on page 2-12.
For torque values, see page 2-16 and 2-17.
LEGEND
Positive (+)
Battery cable
Negative (–)
Battery cable
BTS cable