Installation Guide
Table Of Contents
- Conext™ XW+ Inverter/Charger Installation Guide
- Conext™ XW+ Inverter/Charger Installation Guide
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext 120/240VAC Breaker Kit for Conext XW+ PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Conext 3 Phase Breaker Kit for Conext XW+ PDP
- 100A, 125VDC Breaker Master Pack (12 units)
- 80A, 125VDC Breaker Master Pack (12 units)
- 60A, 160VDC Breaker Master Pack (48 units)
- 250A, 160VDC Breaker Master Pack (6 units)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger and Conext XW+ Power Distribution Panel
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW+ units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring a Balanced Three-Phase System
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
- Wiring Diagrams
- Split-Phase to Single-Phase Conversion Instructions
Conext XW+ Inverter/Charger Accessories Installation
5–2 975-0239-01-01 Rev G
This manual is for use by qualified personnel only
Conext Combox Installation
The Conext XW+ Inverter/Charger can be controlled remotely by connecting a
Conext ComBox.
The Conext ComBox allows access to programming features of the Conext XW+
and allows the system to be modified to specific installation requirements.
For installation instructions, see the Conext Combox Owner’s Guide
(975-0679-01-01).
Conext System Control Panel Installation
The Conext XW+ can be controlled remotely by connecting a Conext System
Control Panel (SCP).
The SCP allows access to programming features of the Conext XW+ and allows
the system to be modified to specific installation requirements.
The SCP can be connected to the Conext XW+ Inverter/Charger through one of
the following two methods:
• via the Xanbus network (see “Installing the SCP via the Xanbus Network” on
page 5–3), or
• by replacing the inverter information panel with the SCP (see “Replacing the
Inverter Information Panel with the SCP” on page 5–4).