Installation Guide
Table Of Contents
- Conext™ XW+ Inverter/Charger Installation Guide
- Conext™ XW+ Inverter/Charger Installation Guide
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext 120/240VAC Breaker Kit for Conext XW+ PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Conext 3 Phase Breaker Kit for Conext XW+ PDP
- 100A, 125VDC Breaker Master Pack (12 units)
- 80A, 125VDC Breaker Master Pack (12 units)
- 60A, 160VDC Breaker Master Pack (48 units)
- 250A, 160VDC Breaker Master Pack (6 units)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger and Conext XW+ Power Distribution Panel
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW+ units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring a Balanced Three-Phase System
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
- Wiring Diagrams
- Split-Phase to Single-Phase Conversion Instructions
Electrical Specifications
975-0240-01-01 A–3
Conext XW+ Overload Capability
Loads connected to the inverter are seldom constant, and large loads are often
operated for short periods. To accommodate larger loads, the Conext XW+ can
temporarily exceed its continuous output power rating.
The graphs below illustrate approximate operation time versus load. Inverter
operation time during overload is limited by both inverter internal temperature
protection and by the product of AC output current and elapsed time.
Power Factor Corrected Charging PF (0.98)
Typical Transfer Time 8 ms
a.Automatically adjusts when entering Sell Mode. This unit or system is provided with fixed trip limits
and shall not be aggregated above 30 kW on a single Point of Common Connection.
b.Conext XW+ 6848 NA (Part Number 865-6848-01)
c.Conext XW+ 5548 NA (Part Number 865-5548-01)
Table A-1 Conext XW+ Inverter/Charger Electrical Specifications
Conext XW+ 6848 NA Conext XW+ 5548 NA
10
0
10
1
10
2
10
3
10
4
10
5
10
6
5500
7000
9000
9500
Time in Seconds
Line-Line (240 V) Load [W]
Conext XW+ 5548 UL L-L Inverter Surge Profile
5 Minutes
30 Minutes
Surge Power Versus Time