Installation Guide

Single-Inverter System (Backup Only) Without a Conext XW+ Power Distribution Panel
975-0239-01-01 Rev G B–3
This manual is for use by qualified personnel only
Single-Inverter System (Backup Only) Without a Conext XW+ Power Distribution Panel
Figure B-1 Single-Inverter System (Backup Only) Without a Conext XW+ Power Distribution Panel
1
2
3
4
5
6
7
8
6
9
NG
L1 L2
3
1
2
4
5
7
10
10
NL1L2NL1L2NL1 L2
AC IN
GRID
AC OUT
INV
OUT
AC IN
GEN
8 9
Standby
Event/Warning
Conext XW SCP
L2L1
LEGEND
SCP (optional)
AGS (optional)
Main utility panel
Inverter load sub-panel
AC generator
Generator disconnect
Negative ground bus
Circuit breaker/
Fuse block (optional)
Battery bank
AC Sync cable
Ground
Xanbus cable
Hot L1
Hot L2
Neutral
Actual wiring requirements may vary.
Cable routing may vary.
See Knockout Selection on page 2-5 and Communications Network Preparation on page 2-12.
For torque values, see page 2-16 and 2-17.
For torque connections to the battery terminals, consult the battery manufacturer’s recommendations.
DC disconnect
Positive (+)
battery terminal
Positive (+)
battery cable
Negative (-)
battery terminal
Negative (-)
battery cable