Installation Guide
Table Of Contents
- Conext™ XW+ Inverter/Charger Installation Guide
- Conext™ XW+ Inverter/Charger Installation Guide
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext 120/240VAC Breaker Kit for Conext XW+ PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Conext 3 Phase Breaker Kit for Conext XW+ PDP
- 100A, 125VDC Breaker Master Pack (12 units)
- 80A, 125VDC Breaker Master Pack (12 units)
- 60A, 160VDC Breaker Master Pack (48 units)
- 250A, 160VDC Breaker Master Pack (6 units)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger and Conext XW+ Power Distribution Panel
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW+ units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring a Balanced Three-Phase System
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
- Wiring Diagrams
- Split-Phase to Single-Phase Conversion Instructions
Single-Inverter System Renewable Energy (Solar)
975-0239-01-01 Rev G B–5
This manual is for use by qualified personnel only
Single-Inverter System Renewable Energy (Solar)
Figure B-3 Single-Inverter System Renewable Energy (Solar)
NL1L2NL1L2NL1 L2
AC IN
GRID
(AC1)
AC OUT
INV
OUT
AC IN
GEN
(AC2)
Standby
Event/Warning
Conext XW SCP
NG
L1 L2
L2L1
1
2
3 4
1
2
4
5
6
7
8
7
8
3 6
9
5
9
13
9
11 12
11
10
12
10
Main utility panel
Inverter loadAC generator
Generator disconnect
AC Sync cable
Ground
Xanbus cable
Hot L1
Hot L2
Neutral
DC combiner boxAC breakers
Positive (+)
battery terminal
Positive (+)
battery cable
Negative (-)
Negative (-)
battery cable
battery terminal
sub-panel
Conext MPPT
LEGEND
Network ter minator
PV array Battery bank
CC
PV
Solar charge
DC positive (+)
DC negative (-)
controller
Actual wiring requirements may vary.
Cable routing may vary.
See Knockout Selection on page 2-5 and Communications Network Preparation on page
2-12.
For torque values, see page 2-16 and 2-17.
For torque connections to the battery terminals, consult the battery manufacturer’s
recommendations.
SCP (optional) AGS (optional)
BTS cable