Installation Guide
Table Of Contents
- Conext™ XW+ Inverter/Charger Installation Guide
- Conext™ XW+ Inverter/Charger Installation Guide
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext 120/240VAC Breaker Kit for Conext XW+ PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Conext 3 Phase Breaker Kit for Conext XW+ PDP
- 100A, 125VDC Breaker Master Pack (12 units)
- 80A, 125VDC Breaker Master Pack (12 units)
- 60A, 160VDC Breaker Master Pack (48 units)
- 250A, 160VDC Breaker Master Pack (6 units)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger and Conext XW+ Power Distribution Panel
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW+ units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring a Balanced Three-Phase System
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
- Wiring Diagrams
- Split-Phase to Single-Phase Conversion Instructions
Split-Phase to Single-Phase Conversion Instructions
C–10 975-0239-01-01 Rev G
This manual is for use by qualified personnel only
Upgrading the Firmware
To upgrade the firmware, refer to instructions in the Conext Configuration Tool
User’s Guide (Document Part Number 975-0365-01-01). If you do not have this
guide, download it from www.schneider-electric.com.
You will also need to connect the Conext XW+ Inverter/Charger to your computer
using a USB-to-Xanbus adapter (Product Part Number 865-1155).
To upgrade the firmware:
1. Download the USB-to-Xanbus adapter driver (available on www.schneider-
electric.com).
2. Connect the USB-to-Xanbus adapter to a USB port on your computer, and
then install the downloaded driver. See the Conext Configuration Tool User’s
Guide for detailed instructions.
3. Download the latest firmware for your Conext XW+ Inverter/Charger from
www.schneider-electric.com and save it onto your computer.
4. Make sure nominal DC voltage is present at the unit’s DC terminals.
5. Download the latest Conext Configuration Tool software from
www.schneider-electric.com and install it onto your computer.
6. Run the Conext Configuration Tool.
7. Select Firmware > Convert Phase from the Tools menu and follow the on-
screen instruction to complete the conversion.
8. Record the new firmware version for future reference.
Figure C-7 Upgrading the firmware