Installation Guide
Table Of Contents
- Conext™ XW+ Inverter/Charger Installation Guide
- Conext™ XW+ Inverter/Charger Installation Guide
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext 120/240VAC Breaker Kit for Conext XW+ PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Conext 3 Phase Breaker Kit for Conext XW+ PDP
- 100A, 125VDC Breaker Master Pack (12 units)
- 80A, 125VDC Breaker Master Pack (12 units)
- 60A, 160VDC Breaker Master Pack (48 units)
- 250A, 160VDC Breaker Master Pack (6 units)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger and Conext XW+ Power Distribution Panel
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW+ units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring a Balanced Three-Phase System
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
- Wiring Diagrams
- Split-Phase to Single-Phase Conversion Instructions
Introduction
1–2 975-0239-01-01 Rev G
This manual is for use by qualified personnel only
Overview
The Conext XW+ is a modular building block sine-wave inverter/charger that can
be used for residential and commercial battery based off-grid, grid backup, and
grid interactive applications.
The Conext XW+ is a self-contained DC to AC inverter, battery charger, and
integrated AC transfer switch. It is configurable in a hybrid system to operate with
generators and renewable energy sources. These configurations are capable of
extending battery based off-grid/backup autonomy.
Inside the Box
Conext XW+ Inverter/Charger and System Components
The following system components are included in this package. If any items are
missing, contact your authorized dealer.
Note: The Conext XW+ 5548 NA and Conext XW+ 6848 NA inverter/chargers are
designed for operation with single phase, three wire (120 V/240 V) AC sources
and should not be connected to a three-phase AC source.
Figure 1-1 Conext XW+ Inverter/Charger and System Components
Network terminator
DC terminal covers
Battery Temperature
Sensor (BTS)
Air filter
Mounting plate
Conext XW+ Inverter/ChargerAUX port connector
and hardware