Installation Guide
Table Of Contents
- Conext™ XW+ Inverter/Charger Installation Guide
- Conext™ XW+ Inverter/Charger Installation Guide
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext 120/240VAC Breaker Kit for Conext XW+ PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Conext 3 Phase Breaker Kit for Conext XW+ PDP
- 100A, 125VDC Breaker Master Pack (12 units)
- 80A, 125VDC Breaker Master Pack (12 units)
- 60A, 160VDC Breaker Master Pack (48 units)
- 250A, 160VDC Breaker Master Pack (6 units)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger and Conext XW+ Power Distribution Panel
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW+ units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring a Balanced Three-Phase System
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
- Wiring Diagrams
- Split-Phase to Single-Phase Conversion Instructions
Optional Accessories
975-0239-01-01 Rev G 1–5
This manual is for use by qualified personnel only
Optional Accessories
The following optional accessories are available for the Conext XW+ Inverter/
Charger.
For an up-to-date list, call an authorized dealer or visit
www.schneider-electric.com.
Conext XW+ Conduit Box
Part Number
865-1025-01
The Conext XW+ Conduit Box provides an enclosure over the bottom of the
Conext XW+ and covers the cabling that runs underneath.
For installation instructions, see “Installing the Conext XW+ Conduit Box” on
page 2–10 of this Guide.
Conext XW+ Power Distribution Panel
Part Number
865-1015-01
The Conext XW+ Power Distribution Panel (PDP) is factory wired and labelled
with everything to support a single-inverter installation.
Internal wiring and breakers can be added to expand the Conext XW+ with up to
three inverters, four charge controllers, or other equipment to support 120/
240 volt, three-wire, single-phase systems.
The PDP interfaces with the following Conext products:
• Conext XW+ 5548 NA and Conext XW+ 6848 NA Inverter/Chargers
• Conext MPPT Solar Charge Controllers (breakers and wiring not included)
• C-Series Charge Controllers (breakers and wiring not included).
Figure 1-3 Conext XW+ Conduit Box
Note: Your installation may require the inclusion of the Conext XW+ Conduit Box,
depending on local electrical code. Consult your local electrical authority to
ensure your installation is code-compliant.