Installation Guide
Table Of Contents
- Conext™ XW+ Inverter/Charger Installation Guide
- Conext™ XW+ Inverter/Charger Installation Guide
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext 120/240VAC Breaker Kit for Conext XW+ PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Conext 3 Phase Breaker Kit for Conext XW+ PDP
- 100A, 125VDC Breaker Master Pack (12 units)
- 80A, 125VDC Breaker Master Pack (12 units)
- 60A, 160VDC Breaker Master Pack (48 units)
- 250A, 160VDC Breaker Master Pack (6 units)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger and Conext XW+ Power Distribution Panel
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW+ units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring a Balanced Three-Phase System
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
- Wiring Diagrams
- Split-Phase to Single-Phase Conversion Instructions
Optional Accessories
975-0239-01-01 Rev G 1–7
This manual is for use by qualified personnel only
Conext XW+ Connection Kit for INV2 INV3 PDP
Part Number
865-1020-01
The Conext XW+ Connection Kit is the extension kit required for connecting a
second or third Conext XW+ Inverter/Charger in the same system.
The Conext XW+ Connection Kit includes the components shown below.
Figure 1-5 Conext XW+ Connection Kit
#2 AWG
XW+ Conduit Box
RapStraps
TM
#6 AWG AC wiring
Bus bar for DC positive
AC Sync and Xanbus cables
ground wire
GJ250A 160 VDC, 3/8"
(includes 1 conduit bushing)
#4/0 AWG Arctic Ultraflex Blue™
stud DC breaker
Custom designed
bypass interlock plate
battery cables
(includes 4 conduit bushings)
Four-tab power
distribution jumpers