Installation Guide
Table Of Contents
- Conext™ XW+ Inverter/Charger Installation Guide
- Conext™ XW+ Inverter/Charger Installation Guide
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext 120/240VAC Breaker Kit for Conext XW+ PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Conext 3 Phase Breaker Kit for Conext XW+ PDP
- 100A, 125VDC Breaker Master Pack (12 units)
- 80A, 125VDC Breaker Master Pack (12 units)
- 60A, 160VDC Breaker Master Pack (48 units)
- 250A, 160VDC Breaker Master Pack (6 units)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger and Conext XW+ Power Distribution Panel
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW+ units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring a Balanced Three-Phase System
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
- Wiring Diagrams
- Split-Phase to Single-Phase Conversion Instructions
Optional Accessories
975-0239-01-01 Rev G 1–9
This manual is for use by qualified personnel only
Conext System Control Panel
Part Number
865-1050-01
The Conext System Control Panel (SCP) gives a single point of control to set up
and monitor your entire Conext XW+ Inverter/Charger installation.
Featuring a graphical, backlit liquid crystal display, the SCP displays
configuration and diagnostic information for devices connected to the network.
For installation instructions, see “Conext XW+ Inverter/Charger Accessories
Installation” on page 5–1 of this Guide.
Conext Automatic Generator Start
Part Number
865-1060-01
The Conext Automatic Generator Start (AGS) can automatically start and stop a
generator, providing your Conext XW+ Inverter/Charger with power to recharge
depleted batteries while powering your loads. The AGS adds intelligence to
power management and minimizes time spent monitoring batteries and inverter
loads.
For more information, see the Conext Automatic Generator Start Owner’s Guide.
Figure 1-8 Conext System Control Panel
Standby
Event/Warning
Conext XW SCP
Figure 1-9 Conext Automatic Generator Start