Installation Guide
Table Of Contents
- Conext™ XW+ Inverter/Charger Installation Guide
- Conext™ XW+ Inverter/Charger Installation Guide
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext 120/240VAC Breaker Kit for Conext XW+ PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Conext 3 Phase Breaker Kit for Conext XW+ PDP
- 100A, 125VDC Breaker Master Pack (12 units)
- 80A, 125VDC Breaker Master Pack (12 units)
- 60A, 160VDC Breaker Master Pack (48 units)
- 250A, 160VDC Breaker Master Pack (6 units)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger and Conext XW+ Power Distribution Panel
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW+ units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring a Balanced Three-Phase System
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
- Wiring Diagrams
- Split-Phase to Single-Phase Conversion Instructions
Pre-Installation and Wall-Mounting
2–2 975-0239-01-01 Rev G
This manual is for use by qualified personnel only
Pre-Installation
Before installing the Conext XW+ Inverter/Charger, read all instructions and
cautionary markings in this Guide.
Planning the Installation
• Read this entire chapter before beginning the installation. It is important to
plan the installation from beginning to end.
• Assemble all tools and materials needed for the installation.
Installation Tools and Materials
To complete the installation, you will need the following tools:
❐ Socket wrench, appropriately sized
❐ Phillips head screwdriver, appropriately sized
❐ Level
Depending on your installation, additional hardware may be required.The
following items are not included with the Conext XW+ Inverter/Charger:
❐ Battery cables
❐ Grounding wire: #14 AWG to #2 AWG (1.63mm to 6.54mm)
❐ Lag bolts to secure the mounting plates
❐ Screws for mounting the Conduit Box
❐ Additional wiring to connect the PDP to the inverter load sub-panel and utility
grid
❐ Appropriate materials and hardware for additional wall-mount support
Note: Obtain all necessary permits prior to starting the installation. Installations
must meet all local codes and standards. Installation of this equipment
should only be performed by skilled personnel such as qualified electricians and
Certified Renewable Energy (RE) System installers.
WARNING
HEAVY EQUIPMENT
The Conext XW+ Inverter/Charger weighs approximately 120 lbs. (54 kg). A
two-person lift is required. To prevent personal injury, always use proper lifting
techniques during installation.
Failure to follow these instructions can result in death or serious injury.