Installation Guide
Table Of Contents
- Conext™ XW+ Inverter/Charger Installation Guide
- Conext™ XW+ Inverter/Charger Installation Guide
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext 120/240VAC Breaker Kit for Conext XW+ PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Conext 3 Phase Breaker Kit for Conext XW+ PDP
- 100A, 125VDC Breaker Master Pack (12 units)
- 80A, 125VDC Breaker Master Pack (12 units)
- 60A, 160VDC Breaker Master Pack (48 units)
- 250A, 160VDC Breaker Master Pack (6 units)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger and Conext XW+ Power Distribution Panel
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW+ units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring a Balanced Three-Phase System
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
- Wiring Diagrams
- Split-Phase to Single-Phase Conversion Instructions
Pre-Installation
975-0239-01-01 Rev G 2–5
This manual is for use by qualified personnel only
See Figure 2-2, below, for an example of available knockouts along the top and
side of the Conext XW+ Power Distribution Panel.
Remove your choice of knockouts from the Conext XW+ chassis, Conext XW+
Conduit Box, and/or Conext XW+ Power Distribution Panel. Ensure that no debris
remains inside the chassis. Insert appropriately-sized conduit bushings into each
conduit hole.
Air Filter and AUX Port Connector Installation
Insert the air filter by tucking it into the grooves on the sides of the air vent cover
(See Figure 2-3.)
If you are planning to use the auxiliary (AUX) port features, insert the AUX port
connector into the AUX port. (See Figure 2-3.)
Figure 2-2 Example of available knockouts on the PDP