Installation Guide
Table Of Contents
- Conext™ XW+ Inverter/Charger Installation Guide
- Conext™ XW+ Inverter/Charger Installation Guide
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext 120/240VAC Breaker Kit for Conext XW+ PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Conext 3 Phase Breaker Kit for Conext XW+ PDP
- 100A, 125VDC Breaker Master Pack (12 units)
- 80A, 125VDC Breaker Master Pack (12 units)
- 60A, 160VDC Breaker Master Pack (48 units)
- 250A, 160VDC Breaker Master Pack (6 units)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger and Conext XW+ Power Distribution Panel
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW+ units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring a Balanced Three-Phase System
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
- Wiring Diagrams
- Split-Phase to Single-Phase Conversion Instructions
Pre-Installation and Wall-Mounting
2–6 975-0239-01-01 Rev G
This manual is for use by qualified personnel only
For more information, see “AUX Port” on page 3–5 of this Guide.
Wall-Mounting
A mounting plate is included with each Conext XW+ Inverter/Charger and Conext
XW+ Power Distribution Panel (PDP), designed to meet standards for structural
and seismic stability. When properly installed, the system also meets Section 59
of UL 1741 for Static Loads.
Figure 2-3 Air Filter and AUX Port Connector Installation
WARNING
HEAVY EQUIPMENT
The Conext XW+ Inverter/Charger can cause serious injury if it falls or is
dropped on a person.
For structural and seismic stability, the Conext XW+ Inverter/Charger must be
mounted onto a vertical supporting surface strong enough to support a
minimum of 500 lbs. (227 kg).
Failure to follow these instructions can result in death or serious injury.
AUX port
Air vent
Air filter
AUX port connector