Installation Guide
Table Of Contents
- Conext™ XW+ Inverter/Charger Installation Guide
- Conext™ XW+ Inverter/Charger Installation Guide
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext 120/240VAC Breaker Kit for Conext XW+ PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Conext 3 Phase Breaker Kit for Conext XW+ PDP
- 100A, 125VDC Breaker Master Pack (12 units)
- 80A, 125VDC Breaker Master Pack (12 units)
- 60A, 160VDC Breaker Master Pack (48 units)
- 250A, 160VDC Breaker Master Pack (6 units)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger and Conext XW+ Power Distribution Panel
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW+ units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring a Balanced Three-Phase System
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
- Wiring Diagrams
- Split-Phase to Single-Phase Conversion Instructions
Wall-Mounting
975-0239-01-01 Rev G 2–9
This manual is for use by qualified personnel only
Wall-Mounting the Conext XW+ and PDP
To wall-mount the Conext XW+ Inverter/Charger:
1. Align the flange on the back of the Conext XW+ chassis with the bottom
edge of the mounting plate, as shown in Figure 2-7.
Figure 2-6 Two interlocking mounting plates
Figure 2-7 Wall-mounting the Conext XW+
WARNING
HEAVY EQUIPMENT
The Conext XW+ Inverter/Charger weighs approximately 120 lbs. (54 kg). A
two-person lift is required. To prevent personal injury, always use proper lifting
techniques during installation.
Failure to follow these instructions can result in death or serious injury.
Conext XW+
Mounting
Conext XW+
chassis bracket
chassis flange
plate