Installation Guide
Table Of Contents
- Conext™ XW+ Inverter/Charger Installation Guide
- Conext™ XW+ Inverter/Charger Installation Guide
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext 120/240VAC Breaker Kit for Conext XW+ PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Conext 3 Phase Breaker Kit for Conext XW+ PDP
- 100A, 125VDC Breaker Master Pack (12 units)
- 80A, 125VDC Breaker Master Pack (12 units)
- 60A, 160VDC Breaker Master Pack (48 units)
- 250A, 160VDC Breaker Master Pack (6 units)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger and Conext XW+ Power Distribution Panel
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW+ units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring a Balanced Three-Phase System
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
- Wiring Diagrams
- Split-Phase to Single-Phase Conversion Instructions
975-0239-01-01 Rev G 3–1
This manual is for use by qualified personnel only
3 Wiring the Conext
XW+ Inverter/
Charger and
Conext XW+ Power
Distribution Panel
Chapter 3, “Wiring the Conext XW+ Inverter/
Charger and Conext XW+ Power Distribution
Panel” describes procedures for installing the
Conext XW+ Inverter/Charger.
Topics in this chapter include:
• “Removing the AC Access Panel and PDP
Internal Faceplates” on page 3–2
• “Wiring the Conext XW+ Inverter/Charger with
a PDP” on page 3–7
• “Wiring Additional Conext XW+ units with a
PDP” on page 3–37
• “Wiring a Balanced Three-Phase System” on
page 3–56
• “Wiring the Conext XW+ Inverter/Charger
without a PDP” on page 3–67