Installation Guide
Table Of Contents
- Conext™ XW+ Inverter/Charger Installation Guide
- Conext™ XW+ Inverter/Charger Installation Guide
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext 120/240VAC Breaker Kit for Conext XW+ PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Conext 3 Phase Breaker Kit for Conext XW+ PDP
- 100A, 125VDC Breaker Master Pack (12 units)
- 80A, 125VDC Breaker Master Pack (12 units)
- 60A, 160VDC Breaker Master Pack (48 units)
- 250A, 160VDC Breaker Master Pack (6 units)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger and Conext XW+ Power Distribution Panel
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW+ units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring a Balanced Three-Phase System
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
- Wiring Diagrams
- Split-Phase to Single-Phase Conversion Instructions
About This Guide
975-0239-01-01 Rev G iii
This manual is for use by qualified personnel only
About This Guide
Purpose
The purpose of this Installation Guide is to provide explanations and procedures
for installing the Schneider Electric Conext XW+ Inverter/Charger.
Scope
The Guide provides safety guidelines, detailed planning, and procedures for
installing the Conext XW+ Inverter/Charger and related system components. It
does not provide details about configuration, operation, maintenance, or
troubleshooting. See the Operation Guide or Owner’s Guide of each device for
this information. This Guide does not provide details about particular brands of
batteries, photoelectric cells, or generators. Consult individual battery
manufacturers for this information.
Audience
This Installation Guide is intended for any qualified personnel planning to install
the Conext XW+ Inverter/Charger and related system components. Qualified
personnel have training, knowledge, and experience in:
• Installing electrical equipment
• Applying applicable installation codes
• Analyzing and reducing the hazards involved in performing electrical work
• Installing and configuring batteries
• Selecting and using Personal Protective Equipment (PPE)
Servicing of batteries must only be performed or supervised by qualified
personnel knowledgeable of batteries and the required precautions. Keep
unqualified personnel away from batteries.
No responsibility is assumed by Schneider Electric for any consequences arising
out of the use of this material.
Organization
This Guide is organized into five chapters and three appendices.
Chapter 1, “Introduction” lists and describes the components and basic features
of the Conext XW+ Inverter/Charger.