Installation Guide
Table Of Contents
- Conext™ XW+ Inverter/Charger Installation Guide
- Conext™ XW+ Inverter/Charger Installation Guide
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext 120/240VAC Breaker Kit for Conext XW+ PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Conext 3 Phase Breaker Kit for Conext XW+ PDP
- 100A, 125VDC Breaker Master Pack (12 units)
- 80A, 125VDC Breaker Master Pack (12 units)
- 60A, 160VDC Breaker Master Pack (48 units)
- 250A, 160VDC Breaker Master Pack (6 units)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger and Conext XW+ Power Distribution Panel
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW+ units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring a Balanced Three-Phase System
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
- Wiring Diagrams
- Split-Phase to Single-Phase Conversion Instructions
Wiring the Conext XW+ Inverter/Charger and Conext XW+ Power Distribution Panel
3–4 975-0239-01-01 Rev G
This manual is for use by qualified personnel only
Conext XW+ Power Distribution Panel Inter nal Faceplate Removal
If you are wiring the Conext XW+ Inverter/Charger to a Conext XW+ Power
Distribution Panel (PDP), you will need to remove the two front faceplates from
the PDP.
For easier access to the faceplates, begin by removing the panel door from its
hinges.
To remove the PDP door:
1. Remove the screw at the top hinge of the PDP door and remove the top
section of the hinge.
2. Using your thumb or forefinger, gently pivot the hinge upward as you remove
the PDP door.
To remove the PDP faceplates:
1. Remove the four screws holding the upper faceplate in place.
2. Remove the four screws holding the lower faceplate in place.
Figure 3-2 Conext XW+ Power Distribution Panel faceplate removal
Internal components hidden for clarity