Installation Guide
Table Of Contents
- Conext™ XW+ Inverter/Charger Installation Guide
- Conext™ XW+ Inverter/Charger Installation Guide
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext 120/240VAC Breaker Kit for Conext XW+ PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Conext 3 Phase Breaker Kit for Conext XW+ PDP
- 100A, 125VDC Breaker Master Pack (12 units)
- 80A, 125VDC Breaker Master Pack (12 units)
- 60A, 160VDC Breaker Master Pack (48 units)
- 250A, 160VDC Breaker Master Pack (6 units)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger and Conext XW+ Power Distribution Panel
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW+ units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring a Balanced Three-Phase System
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
- Wiring Diagrams
- Split-Phase to Single-Phase Conversion Instructions
Communication Ports and BTS Port
975-0239-01-01 Rev G 3–5
This manual is for use by qualified personnel only
Communication Ports and BTS Port
There are five communication ports and a Battery Temperature Sensor (BTS) port
located on the bottom of the Conext XW+ chassis (as shown above in Figure
3-3):
• Two Xanbus ports for making network connections between inverters, charge
controllers, and accessories. For more information, see Chapter 4, “Xanbus
Network Installation”.
• Two AC sync ports to connect multiple Conext XW+ Inverter/Chargers in
parallel. For installation instructions, see “Installing AC sync and Xanbus
cables” on page 4–5.
• AUX port: 12 VDC/250 mA output to control a relay, fan, indicator light, or
other device, using a Conext System Control Panel (SCP) or Conext
ComBox. For more information, see “AUX Port” on page 3–5.
• Battery Temperature Sensor (BTS) port: For more information, see “Battery
Temperature Sensor Installation” on page 3–10.
AUX Port
The Conext XW+ Inverter/Charger has a 12 VDC auxiliary (AUX) output that can
be configured to trigger in response to one of the following conditions:
• low battery voltage
• high battery voltage
• low battery temperature
• high battery temperature
• charge bulk exit
• charge absorption exit
• heatsink temperature
• TOD (time of day)
Figure 3-3 Conext XW+ Inverter/Charger communication ports
AUX port
AC sync ports
Xanbus ports
BTS port