Installation Guide

Wiring the Conext XW+ Inverter/Charger with a PDP
975-0239-01-01 Rev G 3–9
This manual is for use by qualified personnel only
Figure 3-5 DC Grounding Using a Conext XW+ Power Distribution Panel
AC INAC OU T AC IN
GRID
(AC1)
AC
LOAD
GEN
(AC2)
NL1L2NL1L2NL1 L2
L1L2
NG
L1 L2
4
1
2
5
3
1. To AC ground bar
Note: May not be required if DC ground
is used instead.
2. To main utility panel
3. To inverter load sub-panel
4. To generator disconnect
Note: Depending on the location of the
generator and local code requirements,
the generator disconnect may be
located in the power distribution panel.
5. To AC generator
Grounding requirements may vary.
Cable routing may vary. See Knockout
Selection on page 2-5 and
Communications Network Preparation
on page 2-12.
For torque values, see page 2-16 and
2-17.
DC Terminal Connections