Installation Guide
Table Of Contents
- Conext™ XW+ Inverter/Charger Installation Guide
- Conext™ XW+ Inverter/Charger Installation Guide
- About This Guide
- Important Safety Instructions
- Contents
- Introduction
- Overview
- Optional Accessories
- Conext XW+ Conduit Box
- Conext XW+ Power Distribution Panel
- Conext XW+ Connection Kit for INV2 INV3 PDP
- Conext 120/240VAC Breaker Kit for Conext XW+ PDP
- Conext MPPT 60 150 Solar Charge Controller
- Conext MPPT 80 600 Solar Charge Controller
- Conext System Control Panel
- Conext Automatic Generator Start
- Conext ComBox
- Conext Battery Monitor
- Conext 3 Phase Breaker Kit for Conext XW+ PDP
- 100A, 125VDC Breaker Master Pack (12 units)
- 80A, 125VDC Breaker Master Pack (12 units)
- 60A, 160VDC Breaker Master Pack (48 units)
- 250A, 160VDC Breaker Master Pack (6 units)
- Pre-Installation and Wall-Mounting
- Wiring the Conext XW+ Inverter/ Charger and Conext XW+ Power Distribution Panel
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW+ Inverter/Charger with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW+ units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring a Balanced Three-Phase System
- Wiring the Conext XW+ Inverter/Charger without a PDP
- Xanbus Network Installation
- Conext XW+ Inverter/Charger Accessories Installation
- Specifications
- Wiring Diagrams
- Split-Phase to Single-Phase Conversion Instructions
Wiring the Conext XW+ Inverter/Charger and Conext XW+ Power Distribution Panel
3–14 975-0239-01-01 Rev G
This manual is for use by qualified personnel only
To connect the Conext XW+ Power Distribution Panel (PDP) to the Conext
XW+ Inverter/Charger:
1. Connect the positive battery cable (pre-installed in the PDP) to the positive
battery terminal at the bottom of the Conext XW+, as shown in Figure 3-9 on
page 3–16.
2. Connect the negative battery cable (pre-installed in the PDP) to the negative
battery terminal at the bottom of the Conext XW+ Inverter/Charger.
3. Attach the DC terminal covers (included with the Conext XW+ Inverter/
Charger) to the bottom of the Conext XW+ DC terminals.
Figure 3-7 Battery terminals (bottom of Conext XW+)
Figure 3-8 Battery cable connection
Positive (+)
Battery terminal
(Red)
Negative (–)
Battery terminal
(Black)
Terminal surface
Battery cable lug
Flat washer
Split-ring washer
3/8-15 x 5/8” bolt
(included)
Copper compression lug
Note: When making the connections, be sure to observe correct hardware
stacking and proper polarity, and ensure that nothing obstructs the connection
between the terminal surface and the battery cable lug. (See Figure 3-8 on page
3–14.)