User Manual

13 of 20
5200UZI WHC2_5921 and 5200EZI WHC2_5922 USB ZB Interface and Ethernet ZB Interface User’s Manual
© 2012 Schneider Electric. All Rights Reserved.
6.2 Reset Button
Using the reset button on the USB ZB interface will reset the ZigBee network
configuration settings.
To reset the ZigBee network configuration settings on the Ethernet ZB interface unit,
press and hold the SETUP button for a long-press, at least 5 seconds.
Before pressing the reset button, try powering the ZB interface off and on again. to
restore connectivity. The unit undergoes a power-on reset test that sets all of the
device states.