User Manual

7 of 20
5200UZI WHC2_5921 and 5200EZI WHC2_5922 USB ZB Interface and Ethernet ZB Interface User’s Manual
© 2012 Schneider Electric. All Rights Reserved.
3.3 5200EZI WHC2_5922 Ethernet USB Interface
The Ethernet ZB interface is connected to a router or switch on the local Ethernet
network. A network patch cable is provided with the unit. Use only the supplied
AC power supply to power the unit. The PC that has Zoolkit software loaded is
connected to the same network (VLAN) as the interface unit. The Control Systems
IP Utility configures IP address for the Ethernet ZB unit on the local network
(VLAN). The interface unit can connect to an available ZigBee network using
E-mode. A typical Ethernet ZB interface installation is shown in Figure 4.
PC with Zoolkit software loaded
Internet
Router or
switch
Ethernet
ZigBee Interface
ZigBee network
Figure 4. Ethernet ZB Interface connected to the local network
The Ethernet ZB interface unit can be installed in a horizontal or vertical position.
Two keyhole slots (see Figure 5) are provided on the bottom of the housing. Choose
a location for the unit where you can access the programming and reset switches.
67.5mm between centres
Allow adequate space for cables
Figure 5. Ethernet ZB Interface mounting holes