User Manual

9 of 20

5200UZI WHC2_5921 and 5200EZI WHC2_5922 USB ZB Interface and Ethernet ZB Interface User’s Manual

5.0 Installation

The installation steps for the USB and Ethernet ZB interfaces differ slightly. The

following sections tell you how to install the type of interface you are using. This

User’s Manual assumes that you have a working ZigBee network and that you have

access to the CIS Web site on the Internet.

If you are installing multiple ZB interfaces at a site, perform the connection and

commissioning steps for each network separately. Note that only one ZB interface of

either type can communicate with a single ZigBee network. If you are working with

multiple ZigBee networks, be sure to give them unique names using Zoolkit.

5.1 USB ZB Interface Unit

Read the requirements before installing the USB ZB Interface.

Requirements

• Load the Zoolkit software application on the PC. The USB ZB interface unit

requires special hardware driver ﬁles that are included with Zoolkit. The software

setup program can be freely downloaded from the CIS Web site:

http://www.clipsal.com/cis/ On the Technical page, select Downloads.

• There must be a free USB port on the PC. At this time Zoolkit runs only on a

Windows operating system. For other system requirements, refer to Zoolkit

documentation.

• There must be a working ZigBee network that the interface unit can join. The

typical range limit for reliable connectivity is 20 metres.

• If you are installing the USB ZB interface in a Wiser Home Control, you should

conﬁgure the Wiser unit (with Toolkit and PICED software) before installing the

USB ZB interface. Zoolkit software is designed to work with the Wiser unit. Refer

to the Wiser Home Control installation documents.

Follow these steps when installing the USB ZB Interface.

1. Start the Zoolkit software application on the PC where you plan to install the

USB ZB interface unit. If you are using a Wiser Home Control as the location for

the interface unit, the Wiser unit must be operational.

2. Install the USB ZB interface unit in an active USB port on the PC or in the

special location provided under the cover of the Wiser Home Control unit. Refer

to Figure 2 and Figure 7 for more information.

The power indicator should be on and the ZigBee status LED should be in the

Orange - continuous state.

3. Make certain that only one local ZigBee network is available for the interface unit

to join. Make sure that the network is within range and is currently operational.

4. Set the ZigBee network in its setup mode so that the interface unit can join.

Continued on the next page.