Manual
Table Of Contents
- SD315O
- Important information
- Table of contents
- About this manual
- 1 Introduction
- 2 Before you begin - safety information
- 3 Technical Data
- 4 Installation
- 5 Commissioning
- 6 Operation
- 7 Examples
- 8 Diagnostics and troubleshooting
- 9 Accessories and spare parts
- 10 Service, maintenance and disposal
- 11 Extract
- 12 Glossary
- 13 Index
24 Drive for stepper motors
3 Technical Data SD315O
0098441113480, V2.00, 03.2011
3.4 Technical data accessories
3.4.1 Cables
Cable specifications CN1
Cable specifications CN2
Cable specifications CN3
Cable specifications CN4
Shield: Depends on EMC limit values, see
chapter 3.1 "Ambient conditions".
Twisted Pair: Not required
PELV: Required
Minimum conductor cross section: Use a conductor with a sufficient cross
section according to the upstream
fuse and the cable length.
Maximum cable length: -
Shield: Required
Twisted Pair: Required
PELV: Required
Minimum conductor cross section: 0.2 mm
2
(AWG 24)
Maximum cable length: -
Shield: Depends on EMC limit values, see
chapter 3.1 "Ambient conditions".
Twisted Pair: Not required
PELV: Required
Minimum conductor cross section: 0.75 mm
2
.
Use a conductor with a sufficient cross
section according to the upstream
fuse and the cable length.
Maximum cable length: 50 m
Shield: Required
Twisted Pair: Required
PELV: Required
Minimum conductor cross section: 0.2 mm
2
(AWG 24)
Maximum cable length: -