Manual
Table Of Contents
- SD315O
- Important information
- Table of contents
- About this manual
- 1 Introduction
- 2 Before you begin - safety information
- 3 Technical Data
- 4 Installation
- 5 Commissioning
- 6 Operation
- 7 Examples
- 8 Diagnostics and troubleshooting
- 9 Accessories and spare parts
- 10 Service, maintenance and disposal
- 11 Extract
- 12 Glossary
- 13 Index
36 Drive for stepper motors
4 Installation SD315O
0098441113480, V2.00, 03.2011
4.3 Electrical installation
Suitability of the cables Cables must not be twisted, stretched, crushed or bent. Use only cables
that comply with the cable specification. Consider the following in deter-
mining suitability of the cables:
• Suitable for drag chain applications
• Temperature range
• Chemical resistance
• Outdoor installation
• Underground installation
4.3.1 Overview of procedure
왘 Connect the housing to the central ground point of the system.
왘 Verify compliance with the EMC requirements, see page 30.
왘 Finally, verify proper installation.
@ WARNING
UNEXPECTED BEHAVIOR DUE TO EXTERNAL OBJECTS
External objects, deposits or humidity can cause unexpected behav-
ior.
• Do not use damaged products.
• Prevent external objects such as chips, screws or wire clippings
from entering the product.
• Do not use products that contain external objects.
Failure to follow these instructions can result in death, serious
injury or equipment damage.
Chapter Page
4.3.3 "Connecting the power stage supply (CN1)" 38
4.3.4 "Connecting the signal interface (CN2)" 41
4.3.5 "Connecting the motor phases (CN3)" 44
4.3.6 "Connecting the signal interface (CN4)" 47