Manual
Table Of Contents
- SD315O
- Important information
- Table of contents
- About this manual
- 1 Introduction
- 2 Before you begin - safety information
- 3 Technical Data
- 4 Installation
- 5 Commissioning
- 6 Operation
- 7 Examples
- 8 Diagnostics and troubleshooting
- 9 Accessories and spare parts
- 10 Service, maintenance and disposal
- 11 Extract
- 12 Glossary
- 13 Index
0098441113480, V2.00, 03.2011
SD315O 4 Installation
Drive for stepper motors 49
Schematic circuit diagram inputs The following illustration provides a schematic overview of the opto-iso-
lated inputs, using the example of the signal input START.
Figure 4.11 Schematic circuit diagram inputs
Schematic circuit diagram output The following illustration provides a schematic overview of the outputs
PULS_OUT_NO and DIR_OUT_NO.
Figure 4.12 Schematic circuit diagram output
Connecting the signal interface 왘 Verify that wiring and cables meet the PELV requirements.
왘 Connect the connector to CN4.
NOTE: The 5 V signal inputs must not be connected to 24 V
dc
.
Cable specifications
~68Ω
~2kΩ
~68Ω
START(24)
START(5)
START(0)
(+)
(-)
(+)
PULS_OUT_NO
0V_EXT
DIR_OUT_NO
Shield: Required
Twisted Pair: Required
PELV: Required
Minimum conductor cross section: 0.2 mm
2
(AWG 24)
Maximum cable length: -