Manual
Table Of Contents
- SD315O
- Important information
- Table of contents
- About this manual
- 1 Introduction
- 2 Before you begin - safety information
- 3 Technical Data
- 4 Installation
- 5 Commissioning
- 6 Operation
- 7 Examples
- 8 Diagnostics and troubleshooting
- 9 Accessories and spare parts
- 10 Service, maintenance and disposal
- 11 Extract
- 12 Glossary
- 13 Index
54 Drive for stepper motors
5 Commissioning SD315O
0098441113480, V2.00, 03.2011
5.2.2 Setting the nominal current
NOTE: Setting a nominal current higher than the nominal current of the
motor may damage or destroy the motor.
Parameter switch S1 allows you to set the nominal current.
왘 Set the nominal current of the motor by means of parameter switch
S1.
NOTE: If the nominal current of the motor is >7.5 A, you must set a
value of ≤67 % for the current reduction.
Switch setting S1 Nominal current of motor
0 (factory setting) [A] 3
1[A]3.7
2[A]4.4
3[A]4.8
4[A]5.2
5[A]5.5
6[A]5.8
7[A]6.2
8[A]6.6
9[A]7
A[A]7.5
B[A]8
C[A]8.5
D[A]9
E[A]9.5
F[A]10