Manual

64 Drive for stepper motors
6 Operation SD315O
0098441113480, V2.00, 03.2011
6.3.2 Reference values via the analog signal input
The movement is started and terminated via the digital signal input
START.
The use of the analog signal input is determined during commissioning,
see chapter 5.2.7 "Setting the source for the oscillator".
NOTE: If the reference values are supplied via the analog signal input,
reference values may neither be supplied via the digital signal inputs nor
as external reference values.
Velocity The velocity is set via the voltage value at the analog signal input.
The velocity for the voltage range from 0 ... 10 V depends on the number
of steps:
NOTE: The velocity range is a theoretical value. The actually possible
velocity depends on the motor used.
Signal output 10V_OUT The signal output 10V_OUT provides a voltage so that you can, for ex-
ample, use an external potentiometer without an additional voltage
source.
Signal state Meaning
0 level
1 level
Terminate movement
Starting a movement
Number of steps Velocity
200 [min
-1
] 0 ... 60000
400 [min
-1
] 0 ... 30000
500 [min
-1
] 0 ... 24000
1000
1)
1) Factory setting
[min
-1
] 0 ... 12000
2000 [min
-1
] 0 ... 6000
4000 [min
-1
] 0 ... 3000
5000 [min
-1
] 0 ... 2400
10000 [min
-1
] 0 ... 1200