Manual

0098441113480, V2.00, 03.2011
SD315O About this manual
Drive for stepper motors 7
About this manual
This manual is valid for SD315O standard products. Chapter 1 "Intro-
duction" lists the type code for this product. The type code allows you to
identify whether your product is a standard product or a customized ver-
sion.
The following manuals belong to this product:
• Product manual, describes the technical data, installation, com-
missioning and the operating modes and functions.
• Motor manual, describes the technical characteristics of the
motors, including correct installation and commissioning.
Source manuals The latest versions of the manuals can be downloaded from the Internet
at:
http://www.schneider-electric.com
Source EPLAN Macros For easier engineering, macro files and product master data are availa-
ble for download from the Internet at:
http://www.schneider-electric.com
Corrections and suggestions We always try to further optimize our manuals. We welcome your sug-
gestions and corrections.
Please get in touch with us by e-mail:
[e-mail]
.
Work steps If work steps must be performed consecutively, this sequence of steps
is represented as follows:
쮿 Special prerequisites for the following work steps
왘 Step 1
컅 Specific response to this work step
왘 Step 2
If a response to a work step is indicated, this allows you to verify that the
work step has been performed correctly.
Unless otherwise stated, the individual steps must be performed in the
specified sequence.
Making work easier Information on making work easier is highlighted by this symbol:
Sections highlighted this way provide supplementary
information on making work easier.
SI units SI units are the original values. Converted units are shown in brackets
behind the original value; they may be rounded.
Example:
Minimum conductor cross section: 1.5 mm
2
(AWG 14)