Manual

76 Drive for stepper motors
10 Service, maintenance and disposal SD315O
0098441113480, V2.00, 03.2011
10.3 Replacing devices
왘 Switch off all supply voltages. Verify that no voltages are present
(safety instructions).
왘 Label all connections and uninstall the product.
왘 Note the identification number and the serial number shown on the
product nameplate for later identification.
왘 Install the new product as per chapter 4 "Installation".
왘 Commission the product as per chapter 5 "Commissioning".
10.4 Shipping, storage, disposal
Note the ambient conditions in chapter 3.1 "Ambient conditions".
Shipping The product must be protected against shocks during transportation. If
possible, use the original packaging for shipping.
Storage The product may only be stored in spaces where the specified permis-
sible ambient conditions are met.
Protect the product from dust and dirt.
Disposal The product consists of various materials that can be recycled. Dispose
of the product in accordance with local regulations.
@ WARNING
UNINTENDED BEHAVIOR
Unsuitable settings or unsuitable data may trigger unexpected move-
ments, trigger signals, damage parts and disable monitoring func-
tions.
• Do not operate the drive system with unknown settings or data.
• Verify that the stored data and settings are correct.
• When commissioning, carefully run tests for all operating states
and potential error situations.
• Verify the functions after replacing the product and also after
making changes to the settings or data.
• Only start the system if there are no persons or obstructions in
the hazardous area.
Failure to follow these instructions can result in death, serious
injury or equipment damage.