Technical information

Input Terminals
2-wire 8 16 16 16
2-wire with status feedback 8 8 8 8
3-wire 8 8 8 8
Input Types
2-wire normally open (NO) or normally closed (NC) X X X X
2-wire NO or NC, with automatic blink notication X X X X
2-wire maintained toggle X X X X
2-wire momentary toggle X X X X
2-wire momentary ON or momentary OFF X X X X
3-wire momentary X X X X
Input timers (1 sec. up to 18 hours) X X X X
Input synchronization - X X X
Sentry® Switch support X X X X
ON delay/OFF delay X X X X
Time Scheduler
Independent schedules - 16 16 16
ON-OFF periods/schedule - 24 24 24
7-day 24-hour repeating schedule - X X X
32 special event/holiday periods - X X X
Automatic daylight savings - X X X
Sunrise/sunset with offsets - X X X
Network time synchronization (requires TCP connection) - - X X
Network Variables
Communications inputs (network accessible) 64 64 64 64
Remote sources (per controller) - - 32 32
Maximum subscriptions - - 256 256
Zones
Maximum number 64 64 64 64
Maximum sources per zone 1 2 4 4
Congurable source logic (OR, AND, XOR, XNOR, NOR, NAND, LAST EVENT) - ^ X X
Maximum remotely operated circuit breakers (per subnet) 168 168 168 168
Blink notice (single, double, delay no blink) X X X X
ON-time X X X X
Networking
RS-232 port/RS-485 port X X X X
Ethernet (10BaseT port) - - X X
Protocols
BACnet - - X X
C-Bus - - - X †
Modbus® ASCI/RTU X X X X
Modbus TCP - - X X
Johnson Controls N2 - X - -
DMX512 - X X X
Front Panel
LED display with cover X - - -
Backlit LCD display - X X X
Password or front panel disable X X X X
Memory
Non-volatile memory for programs and conguration X X X X
On-board capacitor to power clock chip during power outage - X X X
Flash memory for rmware upgrade X X X X
Viewing Options
Event Log - + X X
Strike Counter X X X X
Alarm viewing via Event Log - + X X
Alarm viewing via e-mail - - - X
Web-based setup, control and status monitoring - - - X
Feature
System Level
500 1000 2000 3000
Terminals accept 24-18 AWG conductors Order NF1000G3N2 controller for use with Johnson Controls.
7.5mA maximum load per input terminal.
+
Not available with NF1000G3N2 controllers.
Requires conguration software for setup. † 3000G3C controller
^ And/or last event
POWERLINK
®
LIGHTING CONTROL
+
CONTROLLERS
Controller Feature Comparison
36