User`s guide

63249-420-266A2 Matrix Switcher

06/2010 User's Guide

GENERAL USE GUIDELINES

General installing, cabling and programming tasks and are

described in the C-Bus™ Multi Room Audio Matrix Switcher

Installation instruction bulletin, other component instruction bulletins,

and in the software Help files.

Follow the guidelines below for general use of the Matrix Switcher.

 Leave the equipment powered ON when not in use. The MRA

system uses very little power when not being actively used.

 The digital audio connections from the Matrix Switcher to the

Remote Amplifiers are for MRA system use only. They are not

compatible with A/V equipment from other manufacturers.

 Do not disturb the audio and control cables attached to the rear

panel of the Matrix Switcher. The C-Bus, digital audio and

Ethernet LAN cables look similar. Never plug them into the

wrong sockets. If you are not sure about cable connections,

refer to the Installation Instructions or call your system installer.

Care and Cleaning

Follow these guidelines to properly care for and clean the unit:

 Clean the unit using a soft lint free cloth.

 Do not use chemicals or spray cleaners when cleaning.

 Do not use hard, sharp objects to select the controls.

 Do not remove any covers or panels.

 Place cables where people will not trip over them.

OPERATION

Powering On the Matrix Switcher

To power on the Matrix Switcher, press on the lower part of the

power switch located on the rear panel toggling the switch to the ON

position. When power is applied, the LCD display is active.

Figure 4: Power Switch Location

KEY:

A. Fuse Holder

B. Power Cord Connector

C. Power Switch