User`s guide

Matrix Switcher 63249-420-266A2

User's Guide 06/2010

Selecting a Program for an Audio Zone

Listed below are several ways to change a zone’s input source in a

typical MRA system installation.

 A zone selection button on the Matrix Switcher

 The Source selection buttons on a Desktop Amplifier

 An infrared (IR) remote control used with a Desktop Amplifier

 An appropriately configured C-Bus wall switch or touch screen.

Figure 5: Selecting a Prrogram Source for a Zone

Streaming Audio

If your Matrix Switcher supports audio streaming, program material

can be sent to the audio zones using an Ethernet LAN connection or

a USB thumb drive at the front panel USB port. Use C-Bus Ripple

software to manage streaming content.

NOTE: The USB socket on the back panel is provided for setup and

configuration purposes. It is not used as an audio input.