Product specifications

TECHNICAL SPECIFICATIONS
4
GENERAL
Imaging Device 1/3-inch (effective)
Imager Type CMOS
Imager Readout Progressive scan
Maximum Resolution 2048 x 1536
Signal-to-Noise Ratio 50 dB
Auto Iris Lens Type DC drive
Electronic Shutter Range
1 ~ 1/100,000 sec
Wide Dynamic Range 60 dB
White Balance Range 2,000° to 10,000°K
Sensitivity f/1.2; 2850°K; SNR >24 dB
Color (1x/33 ms) 0.5 lux
Color SENS (15x/500 ms) 0.12 lux
Mono (1x/33 ms) 0.25 lux
Mono SENS (15x/500 ms) 0.03 lux
Dome Attenuation
Clear Zero light loss
Smoked f/1.0 light loss
Construction Cast aluminum body with polycarbonate
bubble
Finish Light gray powder coated
Weight (without lens)
Unit 3.3 lb (1.5 kg)
Shipping 5.0 lb (2.3 kg)
Available Languages Chinese, English, French, German, Italian,
Portuguese, Russian, Spanish, and Turkish
ELECTRICAL
Port RJ-45 connector for 100Base-TX
Auto MDI/MDI-X
Cable Type Cat5 or better for 100Base-TX
Power Input 18 to 30 VAC; 24 VAC nominal or
PoE (IEEE 802.3af class 3)
Power Consumption* <7W
; <40 W with heater operation
Current Consumption
PoE <140 mA maximum
24 VAC
†
<510 mA without heater operation;
<2.5 A maximum with heater operation
Local Storage Micro SD
Alarm Input 10 VDC maximum, 5 mA maximum
Alarm Output 0 to 15 VDC maximum, 75 mA maximum
Service Port External 3-connector, 2.5 mm provides
NTSC/PAL video output
Accessory Port Connects Pelco accessories
Audio Bi-directional: half duplex
Line level/external microphone input;
600 Ohm differential,
1 Vp-p max signal level
Compression G.711 PCM 64 kbit/s
*Does not include optional devices connected to the accessory port.
†
Required for heater operation.
MECHANICAL
Lens Mount CS mount, adjustable
Pan/Tilt Adjustment
Pan 368°
Tilt 160° (10° to 170°)
Rotate 355°
ENVIRONMENTAL
Operational Temperature –22° to 122°F (–30° to 50°C); PoE operates
between 32° to 122°F (0° to 50°C), 24 VAC
power is required for heater operation below
32°F (0°C)
Thermostat Operation Heater thermostatically controlled to operate
below <41°F (<5°C)
Operational Humidity
20% to 80%, noncondensing
IMPACT RESISTANCE
Impact Resistance IK10++ per EN62262 (70J)
7.45
(18.92)
3.26
(8.28)
IN-CEILING
7.68
(19.51)
6.28
(15.95)
SURFACE MOUNT
(Mounting Ring Is Available as an Accessory)
7.63
(19.38)
7.54
(19.15)
Ø 5.00
(12.70)
PENDANT
(Mount Is Available as an Accessory)
NOTE: VALUES IN PARENTHESES ARE CENTIMETERS;
ALL OTHERS ARE INCHES.
Apac Specbook.book Page 4 Tuesday, November 16, 2010 10:10 AM