Instruction manual

18
Sphere System Instruction Manual
19
4. For a surface that cannot or should
not be cut or where damage is
undesirable the pattress can be
secured by using the double sided
tape included. Ensure surfaces are
flat, clean, and dry and dust free.
5. For screw mounting, choose a
location for the pattress ensuring
there are no cables or pipes beneath
the intended mounting position. From
the inside of the pattress drill through
the circular recesses using a 3.5mm
drill. Using suitable screws and wall
plugs if necessary (not supplied),
mount the pattress in position
making sure ‘TOP’ is uppermost.
6. After fixing the pattress in position,
insert the wall module into the
pattress ensuring that the buttons
are facing the correct way, both
pattress and module are marked
‘TOP’ and refit the front plate.
Handheld Controller
Whilst designed for portable use,
the Handheld Controller can be wall
mounted using the bracket supplied.
Fitting instructions:
1. Choose a location for the bracket.
Ensure that there are no hidden
cables or pipes beneath the
intended mounting position.
2. Pull apart the two sections of the
wall bracket which are held together
by a ‘snap fit’. They are designed
to pull apart. (This acts as a safety
feature when they are on the wall.)
3. Holding the rear section of the
bracket against the wall, mark the
desired position of the screw holes
on the wall.
4. Drill suitable holes and fit wall plugs
(6.5mm for the supplied plugs) as
necessary to suit the wall type.
5. Screw the rear section of the
bracket to the wall.
6. Click the front section back onto the
rear section.