Instruction manual

22
Sphere System Instruction Manual
23
Setting Channels
To operate the Sphere system, it is
necessary to ‘assign’ Ceiling and
Floor Receivers to a Controller,
linking them together. This has to be
done for each Receiver.
Setting a Channel
General:
I. Once set, the channels remain assigned even if the mains supply is removed from the Receivers.
II. If a Receiver button is pressed inadvertently during assigning, the Receiver cannot be taken out of
assign mode (LED flashing). To overcome this situation, assign the Receiver in another channel and
then reassign it to the desired channel.
STEP 1
Setting the Controller Mode
Switches
Initially the ‘Mode’ switches must be
set as above. If they are not, alter the
settings as necessary.
Controllers come with a factory preset
house setting. In most cases this will
not need to be altered. However if
installing multiple room systems, or
to use additional Controllers see
‘Setting the Function Switches’ section
on page 30. You will need to make a
note of this setting on pages 40–41
and also in the User Guide and store it
somewhere safe.
STEP 2
Assigning the Receivers
Press and hold the button
on the Receivers selected
for a channel for at
least five seconds – The
connected lights will flash
once and the Blue LED
will start to flash. Further
receivers can be added to
a channel at any time.
Notes:
i. Relay Receiver
LED shows as ‘Orange’
ii. Wall Dimmer Receiver
The front button surrounds
flash Blue.
STEP 3
Selecting the Channel
Press button 1– 5 or 1– 8
to assign the Receivers
to that channel. The
lights will flash once and
then rise. This indicates
that the channel has
been set.
STEP 4
Turn off Lights
Press the centre button
to trun off lights.
Repeat steps 2– 4
until all the Receivers
have been assigned
to channels.
Mode Switches
LED
Button