Instruction manual

16
Sphere System Instruction Manual
17
Wall and Handheld
Controller Installation
and Set-up
Wall and Handheld Controllers
are programmed and operated in
the same way.
Wall Controller
If positioning in an existing switch
location all cables must be made safe
before proceeding.
The Wall Controllers are supplied
with 2 different fixing options, flush
or surface. Please select the best
method for the situation.
Flush Mount
Flush mounting requires the use
of the Grid frame supplied with the
product to mount the Controller into a
wall box, as used to house standard
light switches. This method is ideal
when an existing light switch is to be
replaced as it will avoid any additional
decorating. The unit will fit into a
16mm deep box when terminated
conductors are not present.
Fitting Instructions:
1. Check the wall box and reposition
any terminated conductors and
terminal blocks to ensure that they
do not interfere with the mounting
of the Wall Controller.
2. For installations in metal 1 gang
4 lug boxes the top and bottom
lugs will need to be removed or
bent inwards and out of the way.
3. Remove the face plate prior to
installation by inserting a small flat
blade screwdriver into either of the
two slots on the side of the plastic
frame and gently prising off the
metal plate.
4. Install the grid frame in the wall
box using the screws provided.
The Wall Controller module comes
assembled to the grid frame.
This may be removed to make
installation easier. To remove the
Control module pinch the clips at
the top and bottom of the Control
module and pull it forward. When
the frame is installed the module
can be pressed back into place.
Align the orientation of the module
with the frame (marked TOP).
5. For best performance in both metal
and dry lining boxes, extend the
antenna outside the box through a
knock-out into the wall cavity.
6. Clip the metal front plate onto the
grid frame.
Surface Mount
Surface mounting the Wall Controller
using the pattress supplied avoids
the necessity of cutting a recess in
the wall. This enables location of the
Controller on virtually any surface,
particularly on difficult surfaces such
as glass, tiles, stone walls etc. The
Grid frame is not used.
Fitting instructions:
1. Initially remove the face plate
by inserting a small flat blade
screwdriver into either of the
two slots on the side of the plastic
frame and gently prising off the
metal plate.
2. Remove the Wall Control module
from the grid frame by pinching the
2 clips at the top and bottom of the
unit and pulling the module forward.
3. The Wall Controller pattress can
be fixed in place by two alternate
methods, double sided tape or
screw mounting.