User's Manual

10
6. Connecting to the Ethernet network
6. 1. Card RJ45 connector pinout
The Ethernet card is equipped with a shielded RJ45 connector. The shielding is connected to the drive ground.
Use STP (shielded twisted pair) Ethernet cable.
The transmission speed is detected automatically by the card (10 Mbps or 100 Mbps).
The card can operate in half duplex or full duplex mode, whether connected to a hub or switch, regardless of the transmission speed
(10 Mbps or 100 Mbps).
The card supports the ETHERNET 2 frame format (IEEE 802-3 not supported).
6. 2. Example of connection to an Ethernet network
(1)When the topology is a daisy chain, if one drive is turned off, the other drive(s) stop in response to a communication network fault (CNF).
Redundancy can be added by connecting the first and last drive in the daisy chain to a hub or switch to create a loop.
Pin Signal
1TD+
2TD-
3 RD+
4
5
6 RD-
7
8
8........................1
PLC
ATV61/71 ATV61/71 ATV61/71 ATV61/71 ATV61/71
Daisy chain and/or star topology (1)
Ethernet switch