User's Manual

26
9. Diagnostics
9. 1. Signalling LEDs
The VW3A3310d Ethernet card features 5 LEDs, which are visible through the Altivar 61 / 71 cover.
The first 2 LEDS are respectively dedicated to each Ethernet port.
The third LED is relative to the IP level.
The last 2 LEDs are specific to EtherNet/IP and CIP communication protocol.
(1)The Ethernet card detects IP address duplication each time it connects to the network (power-up or connection to the network).
If the card detects that another device is using the same IP address as itself, it abandons the use of the IP address and triggers the
status: [External fault com.] (EPF2).
If a device with an IP address identical to that of the drive is connected to the network during operation, the condition will not be detected
by the drive (it is the new station that has to disconnect).
LED Color/ state Description
2.1 Off No link
Flashing Green/yellow Power up testing.
Green ON Link at 100 Mbps.
Yellow ON Link at 10 Mbps.
Green BLINK Activity at 100 Mbps.
Yellow BLINK Activity at 10 Mbps.
2.2 Off No link
Flashing Green/yellow Power up testing.
Green ON Link at 100 Mbps.
Yellow ON Link at 10 Mbps.
Green BLINK Activity at 100 Mbps.
Yellow BLINK Activity at 10 Mbps.
2.3 Off Physical connections unplugged - No IP address obtained
Flashing Green/red Power up testing.
Green ON At least one port is connected and an IP address has been obtained.
Green flashing 3 times All ports are unplugged, but the card has an IP address.
Green flashing 4 times Error: Duplicated IP address (1)
Green flashing 5 times The card is performing a BOOTP or DHCP sequence
2.4
“NS”
Off The device does not have an IP address or powered off.
Flashing Green/red Power up testing.
Green ON The device has at least one established Modbus connection (even to the Message Router).
Green flashing The device has not established Modbus connections, but has obtained an IP address.
2.5
“MS”
Off No power is supplied to the device
Flashing Green/red Power Up testing.
Green ON The device is ready.
Green flashing The device is not ready (waiting for cable connection, ...).
Red flashing The device has detected a [Network fault] (CnF).
Red ON The device has detected a [internal com. link] (ILF) communication interruption.
1.1
1.2
1.3
1.4
1.5
2.1
2.2
2.3
2.4
2.5
Port 1 activity
Port 2 activity
Link status
NS “Network status”
MS “Module status”