User Manual

12 of 30

5200WHC2 Wiser Home Controller 2 Installation Instructions

Dynamic IP (DHCP)

Wiser Home

Controller 2

Customer’s

router

Cat.5e patch cable

(supplied with Wiser 2)

PC with access to the Internet

to download: C-Bus Toolkit

Zoolkit, and

PICED software

AC/DC Power Supply

connection here

Cat.5e network cable

Dynamic IP (DHCP)

Set Up the PC for Configuration Tasks

You need a PC to conﬁgure a Wiser Home Controller. 2 After the conﬁguration tasks

are done, you may disconnect the PC from the network, if desired. Refer to Figure 4

in the

Setup Sheet

for cable connections. At this time the PC must have the following

characteristics:

• Windows operating system, i.e., XP, Windows 7, Vista.

• Adequate disk space for setting up the software applications from Schneider Electric

• Internet access using a browser such as Internet Explorer or Firefox

• The logged on user should have administrator-level permissions

For best results:

• The PC and the Wiser 2 should reside on the same subnet in a wired local area

network (LAN) as shown the ﬁgure below.

• Allow the PC and the Wiser 2 to use dynamic IP addressing via DHCP.

• The customer’s ADSL modem needs to provide the PC with access to the Internet for

software downloads.