User Manual
3 of 30© 2013 Schneider Electric. All Rights Reserved.
5200WHC2 Wiser Home Controller 2 Installation Instructions
Technical Support
For further assistance in using this product, consult your nearest Schneider Electric or
Clipsal by Schneider Electric (CIS) Sales Representative or Technical Support Officer.
Technical Support Contact Information
Technical Support email: cis_support@clipsal.com.au
Safety Notice
The Wiser Home Controller 2 (Wiser 2) is designed for indoor use in residences and
businesses. The Wiser 2 operates continuously over long periods without attention from the
user. Therefore, it is important to install and locate the equipment where it will be protected
from heat, dust, moisture and physical damage.
A ‘WARNING’ in this document alerts you to a hazard that, if ignored, could cause serious
injury or a dangerous condition and also tells you how to prevent problems.
A ‘Caution’ warns you that certain actions could cause damage to the equipment or nearby
property. Note that damage to the equipment might not be immediately detected.
WARNING Connected Equipment Can Turn On and Off Unexpectedly.
The Wiser 2 Graphical User Interface (GUI) can control motors, heaters and relays that
are switched automatically. These devices can turn on or off unexpectedly and could
cause serious injury. Always remove power from connected devices before performing
maintenance.
WARNING Battery Safety
Replace the battery only with the type specified in this instruction. Do not dispose of the
old battery in fire. There is a risk of an explosion that could cause serious personal injury.
Caution Do not connect C-Bus to the Ethernet LAN.
The C-Bus network and the Ethernet LAN are NOT electrically compatible. Wiring errors
will cause damage to the equipment and erratic network performance. This could cause
a potentially dangerous condition.
When installing the Wiser Home Controller 2, follow these guidelines:
• Do not disassemble or attempt to modify the unit.
• The battery is the only user serviceable part inside. It is accessible from the cover on
the underside of the Wiser 2 (refer to the Warning above).
• Do not block air ventilation around the Wiser. Allow 25mm space at sides and top.
• Clean the unit with a soft cloth; Do not use any solvents or cleaners.
• Keep the Wiser 2 away from water or other liquids.